| Author | Message | ||
     Patricia Monica Delbono Username: pato Registered: N/A |
I have winhex installed in my laptop. I must make an image from another Pc, but I can't extract the hard disk and I can't shut down this. I have 2 ideas to do this: 1- Put my laptop in red and from here make the image from the hard disk. 2- Put my laptop in red with the pc using a crossover cable Are these possible ideas? If not, which is the best form to obtain this image? Thanks. Patricia | ||
| René Axnix Username: reax Registered: N/A |
Hello! You can connect the two pc with a crossover cable (PC <-> Notebook). Create a network share ("Map Network Drive") on the PC (p.e. "z:"). Put winhex into the shared folder (on your Notebook) and start it on the connected PC (from "z:"). Open the disk on the PC and save the image over the network share. Sorry for my poor english. | ||
| Patricia Monica Delbono Username: pato Registered: N/A |
thanks for your answer. But if i can't connect the both pc and notebook, may I creat an image from the network? I ask you this because in sometimes i can't do my work directly from a hard disk o a pc, due to i can't shut down the systems. Thanks Patricia (Argentina) Sorry for my english, too!!!! |